Trisim Property Maintenance
Gutters and downpipes

Rainwater tanks in Cairns: how gutters, first-flush diverters and screens keep tank water clean

By Trisim Property Maintenance, CairnsLast reviewed

  • 10 min read
  • 6 sources checked
  • 6 questions answered
The short answer

Keep tank water clean by keeping the roof and gutters clean, emptying the first flush diverter, keeping every tank opening screened, and checking the whole system at least every six months. National health guidance adds a sediment check every 2 to 3 years, and Queensland law requires a mosquito-proof screen or flap valve on every tank opening.

Everything that lands on the roof is a candidate for the tank. Leaf litter, dust, droppings and the water that sits in a sagging gutter all travel the same path as the rain, so most rainwater tank maintenance happens before the water reaches the tank at all.

This guide follows that path from the gutter to the tap, using the national health guidance on household rainwater tanks from enHealth, Queensland's mosquito screening law, and the QBCC's line between owner checks and licensed plumbing. For gutters that spill over in heavy rain, start with our guide to why gutters overflow. If you would rather not be on the ladder, our gutter cleaning service clears gutters and downpipes across Cairns, quoted before any work starts.

How a rainwater tank works: the path from roof to tap

A household rainwater tank is fed by the roof, and the gutters are the collection system. According to enHealth's Guidance on use of rainwater tanks, most domestic rainwater tanks are installed above ground and collect run-off from roofs via guttering. The water passes these points in order, and each one is a place to check:

  1. 1The roof, which catches the rain and whatever has settled on it since the last shower.
  2. 2The gutters, which carry the water to the downpipe and hold back leaves if they are kept clear.
  3. 3The downpipe, which takes the water down to the tank or into a buried pipe that runs to it.
  4. 4A first flush diverter, if fitted, which holds back the first dirty water of a shower.
  5. 5The tank inlet, with its leaf filter and insect-proof screen.
  6. 6The tank itself, with its lid, overflow and any sediment on the floor.
  7. 7The pipework and outlets that carry water to the taps.

A fault anywhere upstream shows up in the tank. That is why the checks below start at the gutter rather than inside the tank.

Clean gutters are the first filter for tank water

Much of rainwater tank maintenance is keeping the gutters clean, because they collect what the roof sheds before it reaches the tank. enHealth says roofs and gutters should be cleaned twice a year or more frequently in areas subject to large amounts of windborne dust or leaves. A roof with trees over or beside it fits that second description, so twice a year is the floor rather than the target.

Leaves sitting in a gutter do more than block it. enHealth says gutters should have a sufficient and continuous fall to prevent pooling of water, and that prolonged contact of water with leaves can lower pH, resulting in increased corrosion and the release of metals. It also says roof catchments should be kept clear of overhanging tree branches and vegetation, and leaf filters should protect inlets to rainwater tanks.

If water sits in the gutter for days after rain, or the gutter fills with leaf between cleans, the cleaning frequency needs to go up rather than the tank being left to deal with it.

First flush diverters: worth having, but only if they empty

A first flush diverter catches the first water off the roof in a shower and keeps it out of the tank. enHealth notes there is some evidence that this first flush may contain higher than average amounts of accumulated dust, bird and animal droppings, leaves and other debris, and it still supports simple devices that reduce how much of it is collected.

For an average roof catchment, enHealth suggests the first 20 to 25 litres could be diverted or discarded. Two cautions come with that:

  • A diverter is an extra barrier on top of regular gutter cleaning. enHealth says first flush devices should not be used to replace normal maintenance activities designed to keep roof catchments reasonably clean.
  • A full diverter does nothing. If water remains standing in the diverter from the last shower, enHealth says the diverter cannot do its job. Self-emptying mechanisms are not always reliable, so diverters need to be inspected frequently and, when necessary, emptied manually.

In practice, check the diverter after every run of showers.

In Queensland, mosquito-proofing a tank is a legal duty. Under the Public Health Regulation 2018, each opening of a tank must have either a screen of brass, copper, aluminium or stainless steel gauze with a mesh size of not more than 1 mm, or a flap valve that stops mosquitoes when closed. The occupier, or the owner if no one occupies the place, must keep the tank maintained so it continues to comply. A screen may be removed for maintenance only if it is replaced immediately after the work is finished.

The stakes are real in the north. The Queensland Government says neglected rainwater tanks, boats, tubs or pools can breed thousands of dengue mosquitoes. enHealth adds that water ponding in gutters can provide breeding sites and could lead to eggs being washed into tanks, and that the preferred approach is to keep mosquitoes out of tanks altogether. For the rest of the yard, see our guide to stopping mosquitoes breeding in a Cairns yard.

The six-monthly rainwater tank checklist

enHealth recommends inspecting the roof catchment and tank at least every six months once a tank is installed, and says the cleaning frequency may need to increase if inspections find large amounts of leaf or other debris. Work through the system in this order:

  • Gutters: clear leaf and silt, and check no water is left ponding. enHealth says gutters generally need cleaning as well as inspection.
  • Roof: clear any build-up of leaves and other plant material that will wash into the gutters.
  • First flush diverter: check it is empty and draining between showers.
  • Tank inlet, insect-proofing and leaf filters: clean them, and repair any torn or loose screen.
  • Tank, tank roof and access cover: look for holes or gaps and have them repaired.
  • Inside the tank: look for signs of animals, birds or insects, including mosquito larvae, and close the access point if you find any. enHealth says the larvae check should be done more often than six-monthly in northern Australia.
  • Water: green growth or scum means light is getting in, so find and close the entry points.
  • Pipework: drain sections that do not self-drain, and do not let water pool below taps or outlets.

Do the roof and gutter part from a ladder only in good weather. The Queensland Government's ladder advice is to never use ladders in thunderstorms, rain or wind.

Sediment: check the tank floor every 2 to 3 years

The thing to check for and clean out of a rainwater tank every few years is sediment. enHealth says that, in addition to six-monthly inspections, tanks should be inspected every 2 to 3 years for accumulated sediments, and if the bottom of the tank is covered with sediment the tank should be cleaned. Sediment can be a source of off-tastes and odours, and of chemical contamination.

Cleaning does not always mean emptying the tank. enHealth says sludge can be removed by siphoning without emptying the tank, and that tank cleaning businesses may be available to desludge tanks.

Entering a tank is a different matter. Where cleaning means going inside, enHealth says to take care to ensure adequate ventilation is provided and an additional person is in attendance. Never climb into a tank alone; if the floor needs more than a siphon, a tank cleaning business is the place to start.

Treating tank water and drinking it: what the health guidance says

For most households, routine testing or treatment is not the first step. enHealth says regular chemical or microbiological testing of domestic rainwater tanks is not needed, and that for most people rainwater from well maintained roof catchments and tanks represents a relatively low risk of illness. The key words are well maintained.

If water smells or carries suspended material, enHealth says the most likely sources are accumulated material in gutters, or at the bottom of tanks, or stagnant water in pipe work that does not self-drain. Clean the gutters and check the tank floor before reaching for treatment.

Where treatment is needed, enHealth names chlorination, ultraviolet light and boiling as the most common methods, and says chlorination is a suitable alternative to testing if there are strong concerns about water quality. Follow the dose guidance in the enHealth document rather than guessing. enHealth also says people with lower immune responses, such as the very young or very old, should talk to their doctor about potential risks and consider boiling the water before drinking it.

Where owner checks stop: tank plumbing is licensed work

Cleaning gutters, emptying a diverter and checking screens are owner tasks. Plumbing work on the tank's connection to the house is usually regulated. The QBCC says most plumbing work undertaken in Queensland is regulated and requires a QBCC licensed plumber or drainer. Its category of minor work, which must still be performed by a licensee, includes installing, removing or replacing an automatic switching device for a rainwater tank, and repairing a broken or damaged pipe.

Call a licensed plumber for:

  • A leaking or broken pipe between the tank and the house.
  • Fitting, removing or replacing the tank's automatic switching device.

Ask for the plumber's QBCC licence number before the work starts.

Getting the gutters cleared before the wet

Clean the gutters that feed a tank before the heavy rain arrives. The Queensland Government's prepare your home guidance says to clean gutters and downpipes so water can drain away as quickly as possible. Our pre-wet-season yard and gutter checklist puts the gutters alongside the other jobs worth finishing first, and our guide on how to unblock a downpipe covers the pipe between the gutter and the tank.

If you would rather not climb, Trisim's gutter cleaning service clears the gutter run and the downpipes rather than skimming the visible leaf. Every job is quoted before it starts, Trisim carries public liability insurance, and the team is police-checked. Check the diverter, screens and tank yourself afterwards using the list above. Trisim also mows lawns in suburbs such as Redlynch and Kewarra Beach, so ask about the gutters when you book, or get in touch for a quote.

Good to know

Common questions from Cairns residents

At least twice a year, and more often under trees. enHealth says roofs and gutters should be cleaned twice a year or more frequently where large amounts of windborne dust or leaves land, and that the whole system should be inspected at least every six months. In Cairns, time one clean for before the wet: the Queensland Government says to clean gutters and downpipes so water drains away as quickly as possible.

It catches the first water off the roof in a shower and keeps it out of the tank, because that first flush may carry more dust, droppings and leaf than the rest. enHealth suggests diverting the first 20 to 25 litres for an average roof. A diverter only works if it is empty when rain starts, so check it often and empty it by hand if it is not draining.

Yes. Queensland's Public Health Regulation 2018 requires every opening of a tank to have a brass, copper, aluminium or stainless steel gauze screen with mesh no larger than 1 mm, or a flap valve that stops mosquitoes. The occupier, or the owner if the place is vacant, must keep it that way, and a screen removed for maintenance must go back on straight after.

National health guidance says that for most people, rainwater from well maintained roofs and tanks is a relatively low risk of illness, and routine testing is not needed. The condition is maintenance: clean gutters, working screens and a clean tank floor. enHealth says people with lower immune responses, such as the very young or very old, should talk to their doctor and consider boiling the water first.

Often, yes. enHealth says sludge can be removed by siphoning without emptying the tank, and tank cleaning businesses may also offer desludging. Check the tank floor every 2 to 3 years and clean it if sediment covers the bottom. If cleaning means going inside the tank, enHealth says to ensure ventilation and have another person in attendance, so leave that to someone equipped for it.

For mosquito screening, Queensland's Public Health Regulation 2018 puts the duty to keep the tank mosquito-proof on the occupier, or on the owner if no one occupies the place. Our guide to who cleans the gutters in a Queensland rental covers the gutter side, and property managers can add the tank screens to routine inspections.

Sources

  1. Guidance on use of rainwater tanks, enHealth (Australian Government, hosted by the Australian Centre for Disease Control). Accessed .
  2. Public Health Regulation 2018, Queensland Government (Queensland Legislation). Accessed .
  3. Dengue, Queensland Government. Accessed .
  4. Regulated plumbing work requirements, Queensland Building and Construction Commission. Accessed .
  5. Prepare your home, Queensland Government. Accessed .
  6. Ladder safety, Queensland Government. Accessed .

Last reviewed by Trisim Property Maintenance. Rules and council services change, so check the source before you rely on a date or a fee.

Related services

Lawn mowing around Cairns

Book a gutter clean before the wet

Tell us about the gutters that feed your tank and we will quote the clear before any work starts.

Call nowInstant quote