Trisim Property Maintenance
Gutters and downpipes

How to unblock a downpipe: from the ground first, and where it becomes a plumber's job

By Trisim Property Maintenance, CairnsLast reviewed

  • 10 min read
  • 10 sources checked
  • 6 questions answered
The short answer

To unblock a downpipe, find where the blockage sits, clear the outlet at the top by hand on a dry day, then flush the pipe with a hose fed from inlet to outlet, working from a lower inspection point if it stops. A broken or collapsed pipe is a job for a licensed plumber.

A blocked downpipe turns a clean gutter into an overflowing one, because the water has nowhere to go. Leaf litter and silt can pack into the outlet at the top, a bend partway down, or the pipe where it joins the underground line. Where the plug sits decides how you clear it, and whether you should be the one clearing it at all.

This guide follows a roofing manufacturer's own downpipe maintenance method, adds what Cairns Regional Council says about the pipe out to the kerb, and marks where clearing ends and licensed plumbing begins. If you are still working out whether the downpipe is the problem, start with our guide to gutters overflowing in heavy rain. If you would rather not climb at all, our gutter cleaning service clears gutters and downpipes across Cairns, quoted before any work starts.

Where is the downpipe blocked? Top, bend or underground

The quickest way to find a downpipe blockage is to watch where the water stops. Run a hose into the gutter near the outlet on a dry day, or watch in steady rain from the ground, and match what you see:

  • Blocked at the top: the gutter fills and spills over around the outlet, and little or nothing comes out at the bottom. Leaves are often visible packed into the outlet.
  • Blocked in a bend or partway down: water goes in at the top but backs up after a short run, and may weep from a joint lower down. If water runs down the outside of a downpipe, check where it starts: spilling from the top points to a blockage, a drip from a joint points to a leak.
  • Blocked underground: the downpipe itself flushes clear when you test it from a lower point, but the water still backs up into it, bubbles out where the pipe meets the ground, or never reaches the kerb outlet. Water pooling along the line of the buried pipe is another sign.

Knowing which of the three you have saves climbing a ladder for a blockage that is actually in the ground, and saves digging for one that a handful of leaves at the gutter would fix.

Start from the ground: the checks to do before anyone climbs

Check the bottom of the system first, because those checks need no ladder and sometimes find the whole problem. Work through this list on a dry day:

  • The kerb outlet. Cairns Regional Council says roof water pipes are connected to the gutters and carry the property's water to the lawful point of discharge, typically the kerb and channel at the front, or a pit on site. Clear any leaves or silt you can reach at the kerb outlet from the street.
  • Any grate, cap or opening near the base of the downpipe where it joins the underground pipe. Lift out debris you can reach by hand.
  • Garden waste near the pipe. Council warns that dumping grass and tree clippings into drains may cause blockages during heavy rain, so keep clippings and mulch away from outlets and grates.
  • Wet patches. Council says flow from roof water pipes cannot be directed in a way that causes water to pool and become stagnant, so ponding along the pipe line is worth tracing.

If the water now runs freely to the kerb, the job may be done. If not, the blockage is higher up the downpipe or deeper in the ground.

How to unblock a downpipe, step by step

Lysaght, the steel roofing and rainwater goods maker, sets out a hose method in its downpipe inspection and maintenance guidance. It recommends testing each downpipe for blockage. Steps 3 to 5 below are Lysaght's hose method; the steps either side are practical preparation and checking:

  1. 1Pick a dry, still day. The Queensland Government's ladder safety advice says never to use ladders in thunderstorms, rain or wind.
  2. 2Clear the gutter around the outlet first, then pull the leaves out of the outlet by hand into a bucket, so the debris comes out rather than going further down the pipe.
  3. 3Flush the downpipe. Lysaght says steel downpipes should be cleaned using a pressure water hose directed down each of the downpipes.
  4. 4Feed the hose through. Lysaght says the hose should then be fed into the pipe from the inlet down to the outlet, to make sure there are no obstructions.
  5. 5If the hose stops partway, go to the next access point down. Lysaght notes that constrictions may make it necessary to reach the pipe from inspection points downstream of the inlet.
  6. 6Test the result. Run water into the gutter and check that it comes out freely at the bottom and at the kerb.

Lysaght's advice is to remove a blockage once you find it, to avoid water backing up in the gutters. Before going up, read cleaning your own gutters: ladder safety and tools, which covers ladder setup and the power line in detail.

A compacted downpipe or blocked bend: work from the lower end

A compacted downpipe has silt and leaf packed solid, which can sit at a bend or offset where the pipe changes direction. If flushing from the top does not shift it, reach it from the closest opening below, as Lysaght's guidance on downstream inspection points suggests, and wash or draw the debris out from there.

Take care with tools. Lysaght's maintenance manual for its Lysaght Living products says debris should be removed without damaging the gutter, downpipes, leafguards or overflow devices, and that shovels or hard tools should not be used. That advice is written for its own patio and carport roofs, but the logic of not gouging a thin steel pipe holds for any downpipe.

If the plug will not move with water and hand clearing, stop rather than forcing it. A blockage that survives a hose fed from both ends may be a crushed, displaced or broken section, and that is no longer a clearing job.

When the downpipe goes into the ground: follow it to the kerb

A downpipe that drains into the ground usually feeds a buried roof water pipe that runs to the kerb or to a pit on site. When the downpipe is clear but water still backs up, the blockage is in that buried pipe, and in Cairns it is usually the owner's pipe to look after.

Cairns Regional Council says roof water pipes on Council's verge, between the property line and the kerb, remain the property of the homeowner, who is responsible for maintenance up to and including the kerb adaptor. Council's stormwater page also says broken pipes are the property owner's responsibility to repair.

Clear what you can reach at the kerb outlet and at any ground-level opening. Do not start digging to find a buried pipe without checking for services first: the Electrical Safety Office says to contact Before You Dig Australia for information about underground services where excavation is to be done, because contact with underground cables can be as dangerous as overhead lines. Wet-season soil carries its own risk in the north: the Queensland Government says the bacteria that cause melioidosis are found in deep soil, rising up to muddy surface waters in the wet season. See our guide to melioidosis and yard work in the Cairns wet season.

Where clearing stops: broken pipes are a job for a licensed plumber

Clearing debris out of a downpipe removes a blockage without changing the system. As a general rule for plumbing in Queensland, the QBCC says most plumbing work is regulated and requires a QBCC licensed plumber or drainer, and its category of minor work, which must be performed by a QBCC licensee, includes repairing a broken or damaged pipe. The unregulated list that anyone with the skills may do is short, covering jobs such as replacing a shower head or a tap washer.

Metal fascias and gutters, and roof and wall cladding, sit within the scope of the QBCC plumbing and drainage licence. Stop and call a licensed plumber or drainer when you find:

  • A cracked, split, crushed or collapsed pipe, above or below ground.
  • A downpipe that has pulled away from the gutter outlet or the underground connection.
  • Joints that leak once the pipe is clear.
  • A blockage in the buried pipe that water and hand clearing do not shift.
  • A sagging gutter, or a need for more or relocated downpipes.

Ask for the tradesperson's QBCC licence number before the work starts.

Keep downpipes clear before the wet, not during it

The time to clear downpipes is before the heavy rain. The Queensland Government's prepare your home guidance says to clean gutters and downpipes so water can drain away as quickly as possible, and to prepare your home before storm, cyclone and monsoon season.

After that first clear, check again after big storms. Lysaght's manual for its Lysaght Living products recommends maintenance at least every four months and an inspection after storms; that schedule is written for its own patio and carport roofs, but it is a sensible prompt for a home whose gutters catch leaf from nearby trees.

Our pre-wet-season yard and gutter checklist puts the downpipes alongside the other yard jobs worth finishing before the rain sets in. In a rental, our guide to who cleans the gutters in a Queensland rental sets out who should arrange it.

Getting the gutters and downpipes cleared

If the downpipe is blocked and you would rather not be on a ladder, Trisim's gutter cleaning service clears the gutter run and the downpipes rather than skimming the visible leaf, because a clear gutter feeding a blocked downpipe still overflows. Every job is quoted before it starts. Trisim carries public liability insurance and the team is police-checked.

Trisim also mows lawns in suburbs such as Mount Sheridan and Bentley Park, so ask about the gutters when you book the lawn, or get in touch for a quote. If the clear turns up a broken pipe or a blockage in the underground line, that is the point to bring in a licensed plumber.

Good to know

Common questions from Cairns residents

Watch it in steady rain or run a hose into the gutter near the outlet. If the gutter spills over around the outlet while only a trickle comes out at the bottom, the downpipe is likely blocked. If the downpipe flushes clear from a lower opening but water still backs up, or never reaches the kerb outlet, the blockage is probably in the underground pipe instead.

Sometimes. Start at the bottom: clear the kerb outlet and any grate or opening where the downpipe meets the ground, then test with a hose. A plug at a bend can often be reached from the nearest lower opening. A blockage packed into the outlet at the top usually means a ladder, so leave that for a dry, still day and follow ladder safety advice.

Start with a hose. Lysaght, which makes steel downpipes, says to direct a pressure water hose down each downpipe, then feed the hose into the pipe from the inlet to the outlet to check for obstructions, using lower inspection points for constrictions. Avoid hard tools that could damage a thin pipe. If water and hand clearing do not shift it, call a licensed plumber.

Clear what you can reach at the kerb outlet and any ground-level opening, then stop. Cairns Regional Council says the homeowner maintains roof water pipes up to and including the kerb adaptor, and that broken pipes are the owner's responsibility to repair. Do not dig without checking Before You Dig Australia for buried services, and call a licensed plumber or drainer for a blocked or broken buried pipe.

In Cairns, the repair is the owner's to arrange: Cairns Regional Council says broken pipes are the property owner's responsibility to repair. For a cracked, crushed or disconnected pipe, use a QBCC licensed plumber or drainer rather than patching it yourself, and ask for the licence number before the work starts. Clearing leaves and silt out of a downpipe is a different job from repairing the pipe itself.

At least once before the wet season, and again after big storms. The Queensland Government says to clean gutters and downpipes before storm, cyclone and monsoon season so water can drain away quickly. Lysaght's manual for its own patio and carport products suggests maintenance at least every four months and an inspection after storms, a useful prompt for homes with trees overhanging the roof.

Sources

  1. Downpipe Inspection & Maintenance, Lysaght (BlueScope Steel). Accessed .
  2. Lysaght Living maintenance and structural performance warranty, Lysaght (BlueScope Steel). Accessed .
  3. Stormwater disposal responsibilities, Cairns Regional Council. Accessed .
  4. Regulated plumbing work requirements, Queensland Building and Construction Commission. Accessed .
  5. Unregulated plumbing guide, Queensland Building and Construction Commission. Accessed .
  6. Plumbing and drainage licence, Queensland Building and Construction Commission. Accessed .
  7. Ladder safety, Queensland Government. Accessed .
  8. Powerlines and underground cables, Electrical Safety Office (Queensland Government). Accessed .
  9. Prepare your home, Queensland Government. Accessed .
  10. Melioidosis, Queensland Government. Accessed .

Last reviewed by Trisim Property Maintenance. Rules and council services change, so check the source before you rely on a date or a fee.

Related services

Lawn mowing around Cairns

Book a gutter and downpipe clear

Tell us which downpipe is backing up and we will quote the clear before any work starts.

Call nowInstant quote